So I know my setup is really niche, but here goes nothing

  • I am using Arch Pi on Pi 4
  • Installed cage as a lightweight Wayland compositor
  • Installed mpv + wireplumber + pipewire

I am not quite sure how to use cage to launch a simple “Wayland session (if it even makes sense)”, so that I can send MPV to that display. So I tried cage -s alacritty :1, and it does launch alacritty with it detecting that it is on wayland.

But when I do DISPLAY=:1 mpv ...., the video runs, but there’s no audio. Also there’s no errors shown on mpv either.

The other thing of note is that I tried cage -s Xwayland :1 and the audio+video works perfectly.

So in all:

  1. How do I launch cage to spawn a simple Wayland session? Is this even possible?
  2. How do I solve the audio issue on Wayland?

EDIT: Thanks all for the help. After some investigation, I found out the pipewire somehow is not ran on startup of alacritty, but it did for Xwayland. I noticed that the first play of the video would be audio-less on alacritty, and subsequent ones are fine. It seems like the first run causes pipewire to be started and thus I wrongfully assumed that the daemon was running.

Still strange nonetheless…

  • wuphysics87@lemmy.ml
    1·
    9 months ago

    Seems like a pretty minimal config. I can respect that. Have you tried running with a display manager? E.g. sddm. They will often start with additional options you wouldn’t have starting from tty.

    If sddm does work, you can cat /etc/sddm.conf I believe to see the options it uses and use those when you start from tty

    For the audio, try installing pipewire-pulse

    Finally, arch for arm isn’t officially supported. Your issues could stem from that. You might consider playing around in a VM with both versions to see if you can reproduce your problem.